Recent content by pax

Problem solved. The sensors were not in sync. The readings were 2 inches off. Once I adjusted them to within .1 inch on level ground, everything leveled and stayed level. My guess is the dramatic reading difference confused the computer and it defaulted to deflate to avoid popping the bags...

Interesting. I don't hear the compressor kick on while driving. I wonder if that points more towards an ECU issue?

I honestly didn't pay attention to the numbers, only that they are changing. I am going to check them tonight. Should they always match each other? I am also going to try the off setting while verifying the numbers.

When I start the car before driving, the height will say normal and never changes as it begins to sag. Before I start driving I have space between the bump stop and the axle. After a mile, I am riding hard on the bump stop. If I go low then high and back to normal, it goes back to the original...

I have a stock 2008 GX470. I can set the air suspension at any height and it will stay and not droop at all even after days. Bust as soon as I drive it, within a mile I am in the bump stops. At stop signs I can raise back up. I sprayed everything I can see with soapy water and can’t see any...

I You were right, it was a cable issue. Got the Tacrix one and everything works exactly as it should. Thanks!

I did notice something earlier and am wondering if it could be this: Battery voltage shows 11.8 volts when not running. I even connected a battery charger before starting to connect. With the vehicle running, it bumps to 13.8, but I still can't connect to anything. Could it be a weak battery?

On mine the first two were ECM and Cruise Control. I have tried the VirtualBox (12.20.024) and a 18 something version on a windows 7 32 bit laptop. No luck with any of those setups getting past just 2 modules. I tried doing a virtual ssetup on my Mac with the same results. Do you have a link...

I am using the VirtualBox version posted on this site (12.20.024) and a Mini Vci J2534 Diagnostic Cable with the 1.4.1 firmware.

I have a 2008 GX470 with 180K on it. Trying to program new keys, but Techstream only sees the first 2 modules. All others show white with an asterisk. Anyone ever see this? What am I doing wrong?