Recent content by oya

It fits snug into the hole in the middle but the old one didn’t seem to have one.

Hello all In the process of replacing the brake booster pump. The new part came with an O ring. Can’t figure out where it goes. Any input appreciated

I talked with those guys and had a look. They said they replaced the cam position wire yesterday and it started up they drove it many times yesterday parked it. Tried a cold start this morning and it wont turn over. They say the injectors arent getting power for some reason. I suppose could be...

Hi everyone, been an 80s model lover for a long time. I got a 1999 100 series model recently with just under 200k miles. Running great and we were really happy with it. Then I saw I had a coolant leak needed a new radiator decided to get timing belt done aswell from my mechanic. They put a kit...

Has anyone tried doing a custom one out of plastic? Maybe a plastic replacement could flex and fit inside as one piece?

While replacing the axle seal on the passenger side, decided to disassemble the birfield to see what it looks like. We are not psyched about all the wear& tear and the chips we see. Will appreciate any input. How bad is this? Is it ok to sand the sharp edges, repack everything and drive like...

Does anybody have any input on this product? Do you think it worths the $ ?

I do not need the catalytic converter so i would weld the pipe to my current cc to save some $ If somebody is selling it with the cc here, i would like to get a price for it too (much easier to install)

Hi There Looking for a Y Pipe (only the part between the manifold and cat converter) for a 1996 FZJ80 I will consider if it comes with cat conv too zip12561

plan is to replace the y pipe, we are avoiding the manifold moves, so will try welding a nut first. thank you, will update here!

Hi everyone just looking for some advice. I need to replace a busted y pipe. I broke a stud on the manifold. I think collector stud. These bolts look impossible to remove. I'm thinking about welding a nut onto there upside down with the manifold still attached. Any thoughts? I used a fiber fix...

Hah, i've learned it in vet school! Thanks to you now i learned high-faultin definition as well :)

Thanks a lot! Great to know we can just go ahead as is. At this point, we are trying to finish the job asap so we won't bother opening the passengers' side to switch them but good to know for the future that this can save us some lifetime on birfs. We are working on the long side and tried...

So we tried really hard, the pipe method and also the vice and hammer the star method neither of them worked. The joint seems and sounds fine, can we just clean it thoroughly and repack it with grease and reinstall it? Is there a necessity to disassemble and reassemble? Perhaps to inspect the...

Still trying to get the axle detach from the bir field, meanwhile we see kinda a sulcus on the axle neck whereabout the seal seats. Do we need to replace this axle or if we get to position the seal away from that sulcus (as pin-head suggested), would it hold?