Recent content by OutbackBob

Oh yeah! Beige is the bomb. Colorado Beige for my 1969. Hopefully to get painted within next 12 months.

69 carbs were problematic. Do you have a solenoid like this also?

Thanks Mark, my son-in-law suggests it vents the bowl to vacuum.

Hi Mark: Thanks for the information. I'd rather send my original Carb to you for a rebuild than replace it. What does that solenoid do anyway? Do I need it, seems like your earlier comment is to forget about it? Thanks for your inputs!

Sweet ride !

Thanks.

Thanks for your response! I want to keep my original parts. Is your solenoid operational? Would you send a picture of how it's wired?

Thanks! I'll check out what the replacement should be.

LOL. Since it's not connected it may as well be removed. Really, what did the TOY engineers want this little solenoid to do anyway? I just gots to know.

My carburetor number 60191, manufactured from 3/69 to 9/69 has a solenoid on it with one wire cut. After the engine is warm it's a little cranky to start. Seems like it's rich and I have to open the throttle plate gently a little to start. Where does the missing wire go? I see a sensor on the...

Nice Work!

Well it was a challenge. Cover sill had spot weld holes on the top and rear. I spot welded these to the inner sill frame. The issue was the floor required cutting out rust from the back two inches forward. You can see where i over head welded the floor the the inner sill frame. All seams...

Grind, fill & primer.

Had four rust areas on both sides on the door sill. Rust areas were between the door sill gusset and the outer sheet metal. Cut out the rust, neutralized the rusted gussets, welded in new sheet metal, primer and filled. Getting ready for the paint & body shop.

Got-UR-done, ready for the paint & body shop.