Recent content by OBCruiser

  1. O

    ECU-IG #2 Fuse Blowing

    I ran into a wall and ended ip taking it to a shop of a couple guys that used ti work for Toyota. They took a week of going over the car with fine tooth comb, and finally found that the parking brake teeth had nicked a wire, Easy fix once they found it, but it was very hard to find. They...
  2. O

    ECU-IG #2 Fuse Blowing

    Thanks. I tried that, and in general trying to clear the codes and monitor for what triggered pending codes. I did the gear shifting as you described while refreshing my scanner and checking codes. What I observed is that I don't get any new codes until the fuse blows. Once the fuse blows, I...
  3. O

    ECU-IG #2 Fuse Blowing

    Went over the wiring as carefully as I could in the engine compartment and under the body, and am seeing no signs of rodents or other damage. I am leaning toward testing or just changing the neutral safety switch. I'll probably pull it off after work one night this week. From what I can find...
  4. O

    ECU-IG #2 Fuse Blowing

    Thank you both. I was thinking wiring damage too. It's been garaged all it's life, so I don't think it is rodents. I also haven't found any other rodent evidence. I was thinking maybe a rubbing wire or vibration could have caused the damage. Very little aftermarket wiring. I have a trailer...
  5. O

    ECU-IG #2 Fuse Blowing

    Always a reader and never a poster, until now... My 2016 LC is intermittently blowing the ECU-IG #2 fuse. When this happens it also: - Throws code P0705 (Transmission Range Sensor failure) - Puts the transmission in limp mode - Fails to display one the dash what gear the vehicle is in - The...
Back
Top Bottom