Recent content by nomad8damon

  1. nomad8damon

    @ Anyone come across a 2F Engine distributor bore hole being too small?

    Thanks for the feedback on your previous experience. It gives me a little hope I'm not just a little nuts. I have a friend that is a helicopter mechanic and built a couple FJs. I'm going to bribe him with a few beers to come over and confirm my measurements and sanity. The local FJ shop wasn't...
  2. nomad8damon

    @ Anyone come across a 2F Engine distributor bore hole being too small?

    Thanks everyone, the multiple suggestions are greatly appreciated. I went out this morning with a decent nights sleep and a clear head to take a few more measurements as well as check for any lip that I might not have noticed. There was no lip at all, very smooth, but possibly a bit of a taper...
  3. nomad8damon

    @ Anyone come across a 2F Engine distributor bore hole being too small?

    Thanks Mark! Your statement about my premise being incorrect is one that I do frequently encounter and hopefully you're right! I couldn't agree more. lol Attached is pictures of my dial indicator which I've measured, remeasured, and measured again a dozen times by now. One is pic the measurement...
  4. nomad8damon

    @ Anyone come across a 2F Engine distributor bore hole being too small?

    Good eyes. It's actually flush on the other side (see pics). I'll file that down prior to installation before it goes back in though, it definitely sticks out enough that it could cause an issue. I like the advice to run an OEM dizzy and I'll probably go that route. That being said, it would...
  5. nomad8damon

    @ Anyone come across a 2F Engine distributor bore hole being too small?

    That was my initial though too because I've had similar issues on other non-FJ rebuilds and distributor swaps, but not the case here. I've got another 1.5" to go before it comes close to engaging with the oil pump slot. I've attached a few more pictures with the DUI distributor inserted part...
  6. nomad8damon

    @ Anyone come across a 2F Engine distributor bore hole being too small?

    Thank you for the quick and detailed response! I concur, not a bushing but non-rotating shaft maybe? The issue I have is the bore hole is smaller than that shaft so it doesn't fit in the hole once the gear enters and overlaps the top. Attached is a picture the 3 I've tried. From left to right is...
  7. nomad8damon

    @ Anyone come across a 2F Engine distributor bore hole being too small?

    I'm a noob here, so thank you in advance for any assistance with this question. I've been reading the forums here for a number of years and have yet to find a question I have that hasn't been answered or in the very least discussed here until now. I've searched the depths of the internet, spoken...
Back
Top Bottom