Recent content by Nitecrawler

I see. Thanks.

When I remove the groove compartment to see my ECU, Guess what I found. Someone cut the wire harness and unplugged. Looks sort of amplifier. I had recently installed Double din JVC stereo and everything works.

Thanks i will do that.

Sorry for the confusing,, like I mentioned before usually when i shift lever to 4 lo CDL light is on my dash panel (and ABS light) same time front driveshaft will engaged. Now shift to 4 lo (yes,, I can shift to 4 lo) No CDL light on at dash and front drive shaft doesn't engaged, Meaning the...

The shift lever is moving freely. from H-N-L. The difflock motor should push the folk rod to engage front drive shaft.

Had bad leak from front driveshaft seal. New seal was installed but i had to remove the diff lock in order to put back front seal housing. Installed transfercase back, Now it won't engaged 4lo and no centerdiff lock light. (My FJ don't have difflock button 4lo will engaged automatically and...

Got it. Thanks

Dear gurus. Bad oil leaked front driveshaft so changed the seal, But having fork shaft won't go back as can see. Any Tricks?? Help will greatly appreciate it. BTW,, Lot of people having problems with seal change my case it was real easy no need special tool just remove clips used soft mallets...

CEL shown 83,84,85 code. Said i need upgrade version 89661-60221

Thanks all.

I'm talking about R12 it should have same size as R12 the manifold gage high,low is same.

During the R12 to R134a conversions on my 93 land cruiser found the compressor High Side fitting is smaller than Lower Side fitting. Old school R12 manifold gage high side will not fit to it smaller fitting. It's very odd not to have same size fitting on high,low. Any Ideas and suggestions is...

Sorry, it is sold.

E Brake and New boot.

Power steering $50 + shipping FrontEnd $350.00