Recent content by Nimmity

  1. Nimmity

    What is this part in the engine bay?

    Oil pressure sender?
  2. Nimmity

    What did you find in your cruiser

    Mine was disgusting, found food wrappers, makeup, blood, mouse poop, about $18 and most of a Monopoly set!
  3. Nimmity

    New guy, new project...

    Dashlights! Headlights!
  4. Nimmity

    New guy, new project...

    Small win, went past the wreckers today and picked up the filler flap release. Stays closed now!! Also got a d/s sun visor, complete with gear selection chart (pics to come) and got the transfer oil changed. Instruments are out and it seems the dash lights are getting power and will work when...
  5. Nimmity

    Challenge: Diagnose by picture

    Head gasket implosion! Caused intake hose to be sucked into the engine leading to a small black hole. :D
  6. Nimmity

    New guy, new project...

    Progress!! New radiator and shroud in (had a poorly fitting rad from a 1hz previously) The heater tap had been bypassed, so connected that back up (found that it just leaks, replacement incoming). I had feared that the matrix was leaking but it seems ok. Replaced PHH with silicone hose, easy job...
  7. Nimmity

    New guy, new project...

    Progress!! Now the dreaded bleed....
  8. Nimmity

    Dogs and 60's (pics)

  9. Nimmity

    New guy, new project...

    Front end is coming along, looking much tidier. New shocks, inner axle seals, cleaned and regreased birfs and fresh axle oil.
  10. Nimmity

    New guy, new project...

    Yeah, the people I bought it from mentioned the brake pedal kept going down to the floor....but they "just got used to it"
  11. Nimmity

    New guy, new project...

    Got started the brakes this evening. Passenger side caliper was leaking badly and the truck had no brakes. Caliper was seized, leaking, brake pads were down to metal and rotor was toast! I've got new calipers pads and rotors ready to go on but I'll get in and do axle seal, wheel bearings and...
  12. Nimmity

    80 series running costs

    So they'd be HZJ80. Fzj80's are great but the fuel use is monumental! HZJ105r are great too. Fairly similar to an 80. Best of luck :)
  13. Nimmity

    80 series running costs

    Hey there Aussie here! For that type of trip, I'd be getting a 1HZ DX model. I've known guys with up to 850000ks on that engine and still going. It is by far the most common engine for parts and service here because it is in the hzj Utes that every other farmer/Telstra/national parks ranger etc...
  14. Nimmity

    New guy, new project...

    Thanks for the welcome, so it's a 95 model, I think diesels and petrols are pretty equally common here, especially in the 80 series. It's hard to pick up a dirt cheap diesel as they are more sought after for economy.
  15. Nimmity

    New guy, new project...

    Thanks guys, wheel carrier is an aftermarket job, not homemade. Kind of attaches to the tow hitch and chassis...here's a couple of pics.
Back
Top Bottom