Recent content by muzzam

Noted. Thanks Thanks guys. Will keep it handy as well.

Thanks alot. I will order these 2 as well, just to be ready in case. I searched around and found local pick-up from Toyota Mike Celvert in Houston. So all good on parts. Hope to do it over then weekend. Much appreciated.

👍 I am sure you have done a great job as you explained. I just found out that I have got same issue on my LX570 2011, and I am at the stage of ordering parts now. So far I have listed these few. Part Description Part NO. Manifold Gasket 17171-0S030 PCV valve 12204-380100 Water Inlet...

Happening with mine 2011 as well since for last few days, since it is cold. Is it gone with the weather or should I be concerned? I am planning a long trip in coming months. Do I need to check anything?

Thanks, I just order that last week. Got delivered yesterday and installed. All good now. 👍

What did dealer charge on service? They must have used their own part, which is also more than I can buy on ebay.

I suspect the same. How did you figure that out? Do I have to change whole assembly?

Yes, i tried many times. Kept engine running

Yes, i tried many times. Kept engine running.

Error code comes back in immediately after I clear. Tried to test by all means but no change. I drained the reservoir completely and used metal can of 2.5L AHC fluid to refill.

Ran test and tried to raise any corner, but when I run any single side corner the system doesn’t enable to switch it on. The on/off switch only enables to raise both front or both rear sides. But there is no movement at all. Attached is a data list of values in current condition. I see oil...

I did try to hit the height switch many time but no luck. Reservoir was almost full that’s why there was overflow. Removed some fluid and tried again, no luck. Will run techstream test and will update

Hi, Lx570 2011 Got 4-whee ahc system check light on at 158k As i was already planning to change the globes before it appeared, so i though to start it from there. Order OEM globes (all 4) and OEM AHC fluid. - Did bleed before changing globes. - Replaced globes - Emptied the reservoir and...