OK question time. I'm having more trouble with the Edic so I installed a manual override cable.
Has anyone installed a momentary switch to the Edic motor and used it to throw the arm forward?
Thoughts?
Hi everyone, the olde girl is REGISTERED!!!
It's wet and windy down in Tasmania at the moment however, the COVID-19 restrictions are being lifted, so I have been out for the maiden voyage.
So stocked
Put in some tiedown rails today. They really are useful and make it safer / easier to have the canisters in the back.
Also tested out the tray lights, which are a little brighter than I anticipated, but definatley worth the effort to install!
Little update. I have been battling with some wiring problems over the last month and reading through old forum post to fix EDIC problems.
Managed to find the earth problem (finally) and installed all the wiring for the dash and tray LEDs.
Only a couple of small things to do now, which is...
Now where the heck does it connect to the loom?
Can someone track there 2h sensor wire for me and maybe take a photo of the connection and the wire colour
Here is the tachomoter sensor, which had the wires snapped off. I drilled out the top, soldered new wires in, heat shrunk the wire and put black sealant over the top to keep it protected
OK, so I'm stuck.
I'm fixing the wiring loom that goes from the engine bay to the transfer case.
I managed to buy a new reverse sensor... However
The tacho sensor was toast
Bolted down the tray and went for a test drive around the block and into our small paddock at home. It's so so much smoother with some weight in the back. It seems to be running really well, however I have some gauges to fix.
The lads are coming around, under the promise of free beer, to help...
Update:
So I cut out the box lid and redid it so that the tub can be mounted correctly over the wheels.
Sprayed the primer and raptor liner.
Here are the before and after photos
I'm with you @deadhead7
It would have annoyed me if the tyres did not line up. After much staring and thinking, I have a solution for the box lid, which should work.