Recent content by mikeyee

Isn. Yes

Looking for an ignition cylinder and key for 1991 FJ80.

Can I ask for your help? Working on a bj60 with a 3b. Replaced the diaphragm, drained the fuel tank, drained the separator, replaced and filled the fuel filter, replaced the primer pump. Opened the inspection port on the injection pump to confirm that the fuel rail moves, pumped the primer pump...

Thanks Johnheld & Marco. Engine did not over heat, it seemed odd the very hot temperature in the engine bay. AC was off, and coolant overflow tank was approx 1/3 full. Guess it was nothing to be concerned about. Thanks for your comments.

On a long drive last week there was a burning oil smell and hot air blowing into the cab. We pulled over and lifted the hood. No obvious oil leaks and the engine bay was really hot. Radiator was warm. Thermostat on the dash was below half. Coolant levels were checked, some coolant in overflow...

Hi. I tried ordering c-channel through your website- it said "the store does nog ship to that address...". I live in Canada. Can you PM me. Thank you.

Price ?

Price ?

Do you have ignition cylinder and key ?

Hi everyone. Thanks very much for your comments. I have been using a small jewelry type screwdriver and FSM. But it isn't clear how to get the pins out. I've tried prying up/ down and side to side !. I've flipped open the latches on the connector, but what is the magical trick to get the pins...

Hi. Looking for suggestions on how to remove the pins from combination switch - wiper / headlights. There should be a way to pull out the pins to swap in a new pin. I am replacing the headlight module. Thanks.

Is there a trick to getting the pins out of the connector?.

Great write up, but I am confused. I have a 1991 3FE FJ80. I am replacing the combination switch (84310-6A110), but can only get a 95-97 combination switch (84310-6a261). The 95-97 "works", except for the cruise control. CC plugs and wiring are totally different. On the 1991 CC wires are...

Thank you. Done.