Recent content by Mike Spratt

  1. M

    F engine with 38 weber and chevy HEI

    weber carbs require more advance than 7 degrees, I think as high as 13 or 14.
  2. M

    getting my weber to get up and go

    Just to wrap up this issue, I did fix my problem with my existing 32/26 weber. It was definitely running lean. Instead of changing my jets, I drilled them out one drill bit size at a time. I stopped after drilling both the primary and secondary jet with a 1/16" bit. My 2F now runs like a champ!
  3. M

    getting my weber to get up and go

    summit, is the jet size something I can find on them or is it a buy, try and error type of installation?
  4. M

    getting my weber to get up and go

    I'll contact redline, that's a great idea... and I'll revisit the vacuum leak possibility, because the symptoms sure point in that direction. Thanks for all the feedback, I appreciate everyone's input.
  5. M

    getting my weber to get up and go

    Just reading around and checking under my hood I come to the realisation that I have no PCV valve! The PO swapped it out for a small breather and filter. I also have no breather line from my valve cover. I'll bet this is a part of my troubles.
  6. M

    getting my weber to get up and go

    I'm trying to follow the lead of the PO who set up all this aftermarket stuff, and cut my $$ losses. There seem to be lots of members here happy with their 32/36's, but it seems debatable.
  7. M

    getting my weber to get up and go

    My poor '76 FJ has a long sad story, but for now I'm trying to get it running properly. It is a freshly rebuilt block, and head. It has headers, an aftermarket intake manifold, and a 32/36 weber. After reading all the threads on some very similar problems, I've switched my distributor...
  8. M

    pitted cylinder walls... is this block a dud?

    I'm in Ottawa Ontario, Canada. I'll start looking around for a block up here.
  9. M

    pitted cylinder walls... is this block a dud?

    I am rebuilding a '76 2F out of an FJ40. The head is rebuilt, and I have got the engine rebuild kit, however I've sent my block to the machine shop where they have bored out the cylinders to find that there is still some pitting in the cylinder wall. I'm told that they cannot bore further and...
Back
Top Bottom