Hey guys I appreciate all the different options!
Tires are not going anywhere though, I had 5.29's installed strictly for this setup.
I knew going into it there would be alot involved in properly clearing them, and I'm totally fine with that challenge. What I'm asking here is 1. What would be...
I should have mentioned that this pic is from when the tires first went on.
Flares have been trimmed fairly well and liners have been hammered to allow for decent around town driving. It sounds like I'll be atickubc with my plan for just the 1" body lift.
Any issues that may come up with...
Hey guys! Towards the end of the season I put some new shoes on my 80. Some Toyo MT 38's.
Currently I have a 3 inch lift and a bit of trimming done to accommodate the occasional drive, but it is not offroad ready by any means. Looking for the best way to clear the tires.
My initial thought...
Got home just fine, first impression: not nearly as rough as I was expecting .sure there's a little rubbing going in at the back of the front wheel well but overall not bad for just daily driving around town. Will need quite a bit of work before I can take it wheeling but that's no big deal. I...
Bottom line I just need to be able to get them on and get the rig home .from there I can do the necessary trimmings needed. 4.88 gearing also may be a thing in the near future so not too worried about that aspect.
Hey man yeah that's me! You're the one who suggested I get in here in the first place! Great place with lots if info.
But as for the setup that's what I figured, I don't daily drive my 80 so if I get them on and don't like how it drives or wheels then I'll just hold tight until I can trade out...
Hey guys! My current rig is a 97 fzj80 with just an old man emu 3" lift. Currently running 33's with way too much extra room. Have a friend with some toyo 385/70R16's that wants to make a trade with me to downsize. Anyone know if I can fit these comfortably? I understand I may need to do some...
Yeah it's a work in progress for sure, getting blinkers on the front is the next step for sure haha. But I'm definitely looking to clean up the whole front end and am definitely looking for grill ideas as well.
Not sure if that would work! They are actually wrangler headlights, but I have a friend with a 3d printer so we may be able to CAD up something that will work. Worst case I may just get a used OEM headlight assembly and sort of retro fit the lens around it.