Recent content by LCNorthEast

  1. L

    Intro and yet another AHC thread…

    Success! I swapped out the rear height sensor and everything is working great. I’ve fired up TechStream and the heights look accurate and no trouble codes. I still have to go through and adjust things to make sure the height is where it should be, but the rear no longer sags, and the ride is...
  2. L

    Intro and yet another AHC thread…

    Thank you everyone. I have ordered the part and will update once it’s installed.
  3. L

    Intro and yet another AHC thread…

    Finally got a chance to look things over. I had to run the Active Test a couple of times because I wasn’t sure I was doing it correctly, but results were the same both times. For the Active Test, after inserting the paper clip, turning on the car, holding “down” for 5 seconds I got the...
  4. L

    Intro and yet another AHC thread…

    Thanks for all of that @IndroCruise, that is a lot of useful info in one place and I have a lot to read. I was taking the ohm readings from the contacts where the springs sit inside the sensor, but I didn’t really know what I was doing and I don’t really trust the ohm meter I have. I will try...
  5. L

    Intro and yet another AHC thread…

    I have some ohm readings, but I think I want to get my hands on another ohm meter and try again. Here’s what I came up with though: Truck in ‘High’ With the rear sensor still installed, cover off, springs removed - pin 1 (top) and pin 2 (middle) 79.65k - pin 1 and 3: .58k - pin 2 and 3...
  6. L

    Intro and yet another AHC thread…

    I hooked up Techstream again, put the AHC in Low and these are the readings: FR Height Control Sensor: -1.9 FL Height Control Sensor: -2.0 RR Height Control Sensor: -0.4 Front Pressure Sensor: 0.0 Rear Pressure Sensor: 0.0 Accumulator Press Sensor: 0.0 Then I moved to Neutral and this is what...
  7. L

    Intro and yet another AHC thread…

    Thanks Red Beard. Here she is: I have seen both of those links you posted, but part of my problem is that I can’t remember where I saw information that I read, and some of these threads are 1000 replies deep. I realize adding another thread probably doesn’t help the matter. Also, I’m pretty...
  8. L

    Intro and yet another AHC thread…

    Hello All, New member here, but I’ve been lurking for over a year, and have learned more about this truck here than anywhere else. This place is great! My truck is a 2006 Land Cruiser - 216000 miles (on the dot when I just went to check!) and I’ve owned it for about a year and a half. I’ve put...
Back
Top Bottom