Recent content by kvos40

  1. kvos40

    New guy.

    Yeah so the the ear (item 2) made contact with the pole (item 1) that is now spinning independently of the geared tooth portion of the shaft. The geared tooth part spins with the engine and you can’t spin it by hand but you can spin the upper part with the ears by hand. I added a picture to...
  2. kvos40

    New guy.

    Ok so I finally had sometime to mess with stuff today. took care of the grounding issues ( the negative battery cable was terminated very very poorly.) and fixed the issue on the dizzy harness. Still would not run it was firing off a cylinder or would run on only 3 cylinders for a second and...
  3. kvos40

    FJ80 Heavy Duty Battery Cables

    Do you still have kits with the fuseable link ?
  4. kvos40

    New guy.

    I The plan is to physically inspect the harness obviously. But I’m trying to think Ahead and electrically check it too. To isolate the shield I’d have to find the splice point I17 and figure out where its pinned or crimped.
  5. kvos40

    New guy.

  6. kvos40

    New guy.

    Trust me I wanna learn this truck lol. Dude thanks so much I’ll take a look at this and report back.
  7. kvos40

    New guy.

    What is the shield connected to? The just gives the squiggle which I assume just means it continues on the next page. I tried to follow it but didn’t see the termination. Me and the truck don’t speak the same language. I’m trying to learn tho. I appreciate all your help.
  8. kvos40

    New guy.

    Alright guys we definitely have some grounding issues I cleaned the grounds on the right side of the engine bay while changing the dizzy. Grounds and ohm out at 2.5-3 ran the engine to adjust the dizzy got it running great idle was a little high but ok over all. The engine got to operating temp...
  9. kvos40

    New guy.

    This is gold thanks dude! So I disconnect the water temp sender the water temp switch and she ran good no bouncy idle once it warmed up a bit. While I was sitting there in Drive messing with the center locker. It shut off and wouldn’t start again. I’m gonna test the water temp sw. looks like I...
  10. kvos40

    New guy.

    I’ll dig in the FSM it seems like there is a few different coolant temp sensors. The FSM is kinda all over the place so I’m gonna have to figure out where it is in there.
  11. kvos40

    New guy.

    Fuel looks and smells good. New fuel filter.
  12. kvos40

    New guy.

    I don’t have some of the tools to test electrical parts. I got a basic multimeter and that’s about it. Thanks for the EFI relay info.
  13. kvos40

    New guy.

    I’m trying to add a video but it may not let me from my phone.
  14. kvos40

    New guy.

    I pinned out the OBD 1 and got some code for coolant temp. I wasn’t really sure where to go with that and didn’t think I could cause this. I have the FSM. Honestly I’ve kinda just been shot gunning parts hoping it would change something but I’ve not had luck.
  15. kvos40

    New guy.

    I changed the FPR and the Damper. I’m going to do the Desmog doesn’t the get ride of that switch and vacuum lines??
Back
Top Bottom