I did a little more troubleshooting on this. Although the knock seemed to be coming from the left wheel well, I think it is just easy to hear because the sound of the engine is blocked somewhat by the fender. It is likely coming from the bell housing, tranny or transfer case. I disconnected...
So it appears the hubs are locking and unlocking as they should based on one tire grounded with the other off the ground in 4H. I repeated this multiple times on both sides. I removed the left hub to inspect it and didn't notice anything weird.
I jacked up the rear axle again to see if I...
The 78, fully smogged engine bay is an acquired taste. I have learned how to disconnect and reconnect tubing and hoses with amazing speed and accuracy.
I replaced the trunnion bearings and was very careful to use all original shims in their original positions. They were connected by twist...
Took it out for a spin and it wasn't making the knocking sound until I had driven a few blocks. Then it started again. I went through H2, H4 and L4, locking and unlocking hubs, and back into H4. The knocking was there in all configurations. I did rebuild the knuckles recently. Maybe I...
Thanks Mark. It appears to be in H2 but going from H4 back to H2, makes me unsure that it really is by feel. I will need to wait until our NorCal atmospheric river stops flowing to check it out since the top is off. It makes a lot of sense since the sound was loudest near one of the front...
Search for AB-210 smog. Not holding my breath. I was really hoping for SB-1239 which died on the senate floor in 2016. The u-joints appear to be good and they didn't seem to be where the noise was coming from but I will probably put it back up on stands and try again next weekend.
Noob here. I own a 78 FJ40 CA spec (mostly stock) purchased in 1993 and used as my primary, very multi-purpose vehicle when I was in my 20s. As time went on and I went through many other vehicles, I always vowed to never sell the cruiser. It went through a very long, non-op period because of...