Recent content by JRsLC100

Is there anything left on this truck? Rack and pinion? ABS wheel sensors? Seats? Main cluster?

Is it possible that the 4-Wheel drive shop messed up my seals when installing rear locker?

Mounting hardware? The 4 bolts on the back side?

So I took my rear axle to a machine shop to have the bearing pulled off and a new outer seal put on... They said they can’t remove that bearing with out damaging it! mid the bearing is still good I find it hard to believe that it can’t come off and be out back on... Anyone have any input on this?

Thank you so much! I really appreciate it!

Can anyone tell me what all I need to replace?

So yeah one of the seals is bad....

The bolts holding axle on were basically hand tight! Wtf

Think the bearing is bad?

I wouldn’t doubt it if they did! I had a front lower shock bolt fall out in Moab... went back in to talk to them and they blew me off... The smoke only comes when brakes warm up... I think it’s gear oil?

My e-brake isn’t in at all... need to actually put it back in soon...

So notice smoke coming from rear end of the 100 series after driving... replaced calipers and still smoked... noticed fluid on inside of wheel... At this point I assume it’s an axle seal? I’m pretty green in this area... 1. Any way of knowing which one or a way to check it and find out? 2...