Recent content by haddees

Sweet, I'll have to give a few shops a call over the next week and see what there pricings are, I'd much rather do that than use wheel spacers.

Hey, are there any 15x8 6 stud steel/alloy wheels with an offset of around -50. Everything I have searched has them at around -22. I found some pro comp wheels (pcw51-5883R2.5) with around -50 but I can only find them in America which would cost around $800 to get shipped here which is far too...

I've got a slight issue. When I'm traveling at 100 or so km/h there is a slight slow pulse vibration. Doesn't always do it though.... I don't think Any ideas what it could be?

Haha yeah I'm not sure if he would be hating me or loving me if he saw his truck

Here is the progress so far, it also now has a winch installed but I don't have a photo of it.

I don't have any photos, I had to make a bracket for it and a bolt for the throttle adjustment

Thanks guys, looks like I'll be making them

I am in Melbourne, Australia

Hey, I have a bj73, I have lifted it 3" and I need extended sway bar links. Where can I get these from? I've tried googling etc but I can't seem to find any. Thanks

Ps the guy I bought the bullbar said it came off a 75 series, but after getting it home I found out it was not. Must be off a later model with wider chassis. Anyways can't go wrong for a $50 bullbar and a little fabrication work.

been a bit busy. Put on a bullbar and lift kit.

I have put on 33" recently which made it slightly worse. Tre's have been changed. I haven't checked steering damper. The suspension is stock, I will be putting a 2" on after/over Christmas.

I think I got it reasonable. I adjusted it a little by little. Seems ok. Still a bit of a wander on the road at high speed but nothing anywhere near dangerous. If I adjust it too much it groans, but still doesn't feel firm at full lock. Is it ok for it to groan?

I adjusted it a little but it started to groan so I backed it off again...

Got a question. My steering is a little loose. Not too bad but noticeable. I have replaced the tie rod ends and that helped heaps. The steering shaft has a little play in it before it goes into the box. Would a seal kit fix this or do I have to replace something else?