Recent content by Grond

I don't have a picture, but the terminals are pretty cleaned. I cleaned them first, and then when I took the truck to interstate batteries, the technician went over them thoroughly. Voltage measures the same on battery posts and terminals.

Thanks for the response! So I just went out to the truck and measured 12.32 V on the battery terminals before starting (seems kinda low...). When my wife started it, I watched the voltage drop down to 11-something (it maybe dropped lower but my multimeter was too slow to read it). Once the truck...

Greetings, I have a daily-driver 2000 LX470 with 265k miles on it. I'm having some electrical gremlins on it that I can't figure out, so I'm going to try and document exactly what has happened below, if anyone can help me diagnose. In August 2024, the alternator died on me, and it took out the...

Well that's embarrassing

Couldn't see from the pictures, what size are these?

Would you consider shipping?

Do you have any pictures of the condition they're in?

Do you have the telescoping steering wheel motor?

Do you still have wheel speed sensors? I am looking for driver's side rear.

Would you take $250 plus shipping?

I think I (hopefully) found the culprit. Unplugged the wheel speed sensors and it drives fine, just with ABS and VSC lights on. I decided to take the wheel speed sensors off to check them, and they both pulled out surprisingly easy, without having to take the wheel off and hammer them out as...

Thanks for the help. I will update after I troubleshoot these issues. Dumb question, but is there a difference between VSC and A-Trac? Because it's my A-Trac light that's activating when I accelerate, not my VSC Trac light.

I know the PO said he installed new wheel bearings all around. I guess I need to check those out and make sure they're all snug and installed correctly. Do you know if having the ABS and VSC lights flashing constantly with no pattern when the diagnostic ports are jumped is a good sign that...

Hey everyone, I'm new here, and just purchased my 1st 100-series last week. It's a 2000 LX470 with 250k miles, that I purchased for cheap with the goal of turning it into a DD. Everything runs and drives great, but I had the classic ABS, VSC, A-TRAC, and brake lights on, although brakes were...

Appreciate the help, I'll try and look further into these codes tomorrow. In the meantime I turned the truck on and pumped the brakes a bunch to build up brake pressure, since I was reading a pressure code. The buzzer went off, and now the ABS and VSC codes flash constantly, with no pattern. The...