Recent content by Goode

I do have 264k on the clock. Maybe it's time for a rack replacement. Could be detrimental to my spirit if I change bushings only to realize the rack itself is going south.

I did come across a couple on eBay, but concerned about what product I could receive. LOL

Apologies for hi-jacking. While I am looking to replace steering rack bushings, I'll be doing the following as well... * UCA's (Cruiseroutfitters) * Lower ball joints (Cruiseroutfitters) * Wheel bearings (Cruiseroutfitters) * Diff drop (Cruiseroutfitters)

I left a message with WhiteLine. Will see what they say and report back. Thanks again for your input. Reading all the older posts about replacement bushings, I thought this would be a slam dunk. Placed order with SuperPro, as they showed them in stock. I immediately got a response that they...

Thanks for the quick response. However, mine is a 2005. The bushings linked above are for the earlier racks. I finally made my way to WhiteLine's website, and they don't list bushings for a 2005. Just the earlier model rack bushings.

Are steering gear mount bushings still obtainable? I struck out with the only two places I could find. One was SuperPro, and the other were WhiteLine. WhiteLine was stated to be discontinued. SuperPro said backorder, 8weeks. If I have to wait for SuperPro, I'm willing. I just didn't expect...

My son has baseball practice tonight. I'm going to go pick him up after work and we'll stop by the meeting for a bit. Baseball is only 5mins from there.

So sorry to hear this Jeff. Praying for you and your family.

Last day to register. Get on it.

I'll be there Wed.

I may actually make it back in town in time for tonight. Fingers crossed.

December meeting will be at Barley’s tomorrow night. We no longer have our reservations at Calhoun’s. MEETING AT BARLEY’S DECEMBER 5 at 6:00PM(ish).

Sorry I couldn't be there fellas. Jack has basketball practice Tues and Wed nights through Winter. I'll see ya when I see ya.

Just a wire cup brush on the angle grinder. No chems. I'll go over them again with a pad on the die grinder to finish them off. Then a degreaser and wipe clean. That's prob as far as I can take them. Decided to press the wheel studs out so I could clean around them better. I needed one or two...

If the rain continues and baseball is cancelled, I'll be there tonight. Fingers crossed.