Recent content by GDRFJ80

  1. G

    During rear axle service...

    I went back and played around some more with the preload. I ended up finding a position that allowed 12lbs on the scale, the upper limit of the spec for both sides. It was the first position past "hand tight", the next position would have been way to much preload. Everything looks good and I...
  2. G

    During rear axle service...

    Just did the other side, it was better but acted basically the same. Turn by hand, then start to tighten to next available slot, got 12 lbs. This was of course after the tighten/loosen/tighten sequence in the FSM. I guess I will just go tighter than was was on there originally because I've...
  3. G

    During rear axle service...

    Well then I may be the first one into this axle. Which is kinda funny for Toyota to have some play in there from the factory. I have reinstalled the hub and played around a bit. Basically after many tighten /loosen preload cycles, spin wheel and measuring with a fish scale I came back to the...
  4. G

    During rear axle service...

    Preparing for towing next weekend and decided to PM my rear axle. Ordered all the parts from Dan and read all the threads. I understand how to adjust the lock ring (I think) and after pulling the axles I checked my hub and the preload setting before removing. I was surprised to feel some...
  5. G

    Scangauge II no MAP

    Ok, we have a MAF sensor then? Wonder if the new firmware upgrade will allow us to read that, along with tranny temp and other goodies? Scanguage rep said upgrade for Toyota is coming out in a few weeks.
  6. G

    Scangauge II no MAP

    Just installed the Scangauge and was toggling all the gauge display values. I am unable to read fuel pressure (was expecting that) but I cannot read the MAP display value, it is blank (was not expecting that) - truck is 97. Can everyone else display thier MAP value using the scanguage? Seems...
Back
Top Bottom