So fixed it - and looking at the diagrams spotcruiser and detail from coolerman I did the following:
1. Changed the polarity of the motor to negative ground.
2. re-wired the park mechanism to be inline with the diagram and switch.
and what do you know, working perfect, perhaps little slow to...
Thanks Coolerman - switch is working perfect and it seem the wiper motor is good as well. I guess the big question should be how did the PO end up with a positive ground wiper motor in a negative ground FJ??
I'm no expert but doesn't sound like that's a workable solution and could explain my...
Have determined that the motor is fine - spins perfect if I connect the yellow directly to the motor with power and earth either the LR or LB - low and hight speed.
So either the "park" is causing the issue or it's the switch - and it's a brand new switch so not to sure??
Can some please...
Ok - more digging and it seems that it's a AUS spec wiper and wiring - so wiper motor is positive ground. Not 100% sure what the implication is how how to connect but will keep digging. Anyone with experience please shout!!
Wow, just opened the motor and not sure my assumptions are correct.
LB and LR seems to be correct going to the brushes. But looking at the YELLOW it seems that it's touching the sides of the casing?? Shouldn't this be the power source??
Thanks for the w/d spotcruiser - not sleeping until I have this damn wipers working t'day!!
If I read the diagram correct it says that I need LW, L and earth/ground wire on the cover plate with LR and LB going straight into motor. I'm assuming the "yellow" must then be the L (power source) on...
I have completed (99%) my rebuild and the last part that's driving me up the wall is the wiper motor wiring. The motor works fine but it seems that the PO changed some of the wires. I have referenced all the "wiper motor wiring" threads, including Coolerman but cannot work out which goes...