Recent content by diggs2701

The stereo is aftermarket in a tuffy console. Stereo is connected to power to battery with fuse and the remote turn on (blue wire) is connected to the RADIO fuse. It's almost like the RADIO fuse and DOME light fuse are connected... I think I might take everything I've done and work backwards.

Do you know why the Radio would turn on? It's as if when I connected the Dome light wire everything stayed on with no key.

Thank you, I will try switching to an ACC on the fuse block.

So I was trying to hookup a rocker panel (3 switches and 12v/USB charge port) over the weekend and something very weird happened. One of the rocker panel switches will be used for the DOME light First, I used the 12v for the cig lighter to hook up to the top 12v connector of the rocker panel...

All fixed, turns out it was the button on turn signal switch. It wasn’t reaching the horn wire disc. Took out the spring of the button and extended. Everything works great now, thanks again everyone for the insight. Horn hasn’t worked in years. PO must not have cared.

The button works but now my problem lies in between column. It has one of the old gm turn signal switches with the plate that should spin with the horn wire. Any thoughts on what I can do? Already tested button off with ground wire and used same ground when the button was on the yellow wire but...

Just want to thank everyone for pointing me in the right direction. I followed the wiring and in a nest was a bare black wire which just happened to say to Horn Switch touched a bolt and the horn went off. I felt pretty dumb but can start from there. Still no luck with it on the connector but...

Yes, I took a wire, grounded to frame and touched the pin the horn wire uses. Does the wire go from fuse box/relay straight to harness? Or is the harness wire come from the horn? Thanks.

So I tried grounding the yellow wire to the frame, nothing. So I tried grounding the pin from the connector of wire harness that goes up the steering column and nothing. Does that mean there’s an issue between the relay and harness? Jumping the relay pins does sound the horn. Thanks.

Thank you. I will try that but my button has a gold ring that’s supposed to ground. But I will try that and see if it helps. If I ground the harness connector horn wire should it beep the horn?

Horn under the hood works and relay also works. I tried a wire grounding the button to the frame and still nothing. I’m going to try and see if I connect the middle plug on button and grounding to frame.

Yes, nothing. Does anyone know if I should be getting 12v at the button? Thanks.

Hello, I’m trying to get my horn to function properly. I tested the horn and it does work. I located the relay, pulled it and the ohms tested at 87.5. When I jump the relay top/bottom, I think pin 87 and 30 the horn works. So my guess that the problem lies in the steering column. This fj had a...

Just spray a whole can in there. Will have to do more but that should at least help with the rust getting worse. Now to get some new weather stripping!

First door start, not great, not awful. A lot of weatherstripping to replace in these things haha.