Recent content by declan mcgrath

  1. D

    My 40s transfer case is stuck in 4WD.

    Yes I was doing some research though and I found that the front drive clutch sleeve might be sticking I don’t know why it would but it is
  2. D

    My 40s transfer case is stuck in 4WD.

    I don’t think It was ever taken apart
  3. D

    My 40s transfer case is stuck in 4WD.

    So I’ve been trying to fix up my 40 when I realized the front drive shaft wasn’t spinning freely. So I put the tcase in neutral and it still wasn’t spinning. So I started to mess with the hubs but they were free and the front wheels spun freely. Then I was moving back and forth and going...
  4. D

    I’m thinking about pulling the engine any advice.

    Thank you definitely will do a compression test and a UV test just to make sure, thanks for the uv tip I wouldn’t have thought of that.
  5. D

    I’m thinking about pulling the engine any advice.

    To true I might be opening a can of worms here
  6. D

    I’m thinking about pulling the engine any advice.

    I’ve been trying to figure out a lot about this engine it just weird. But I’ll clean it up really good and figure out exactly what I’ll need for it .
  7. D

    I’m thinking about pulling the engine any advice.

    My wiring is pretty old and brittle so that’s my next project after this and it probably a good idea to replace that oil pump. Thanks man
  8. D

    I’m thinking about pulling the engine any advice.

    Wow thanks man and I have pulled engines In The past but this is my first time pulling a I6 so I’m just a little hesitant you know. Also like ever bout is pretty rusty so I’m gunna be using a lot of pb blaster on this pig. My belts and fuel lines are pretty new.
  9. D

    I’m thinking about pulling the engine any advice.

    You see the block it’s self isn’t leaking it’s just getting that built up old oil look and it’s always something new each week you know. But I do a pressure test to see if any thing is leaking just to be safe. Thanks man
  10. D

    I’m thinking about pulling the engine any advice.

    I probably will just end up rebuilding the engine
  11. D

    I’m thinking about pulling the engine any advice.

    I got a 1970 40 and I’m thinking about pulling the engine just to reseal everything and I was just wondering how hard it was for everyone else and I was looking for a good gasket kit for it or a good rebuild Guide. Any and advice is greatly appreciated thanks.
  12. D

    what would i have to do to run 37 on a stock(ish) 1970 fj40

    Hell ya good to hear cause my fj came with the front already converted
  13. D

    what would i have to do to run 37 on a stock(ish) 1970 fj40

    so iv been looking at some rear disk break conversion kits how does this one look also how would i tell if i have full float axles or semi float https://www.sor.com/CAT292.SOR
  14. D

    what would i have to do to run 37 on a stock(ish) 1970 fj40

    very well put thanks I’ll take it slow go up as times go on and take it one mod at a time
Back
Top Bottom