Recent content by BuckeyeFZJ

Vibrations have been solved. Took cruiser to the shop they put it on the lift and drove it, they said nothing sounded alarming. Pull front end tonight and this is what I found. Shop hasn’t seen it yet but I’m demanding all new parts and labor cost back. Will probably ship them to a Yota shop...

I have a 3” Dobinson lift 35s all new bushings, tie rod ends and IronMan castor correction plates, I believe they were for a 4” couldn’t find ones listed for 3”. Just not sure what else in the front would cause it since it does it without front drive shaft. I’ve built a lot of rigs and this is...

I just got finished with a full knuckle rebuild all new bearings and seals. Had 3rd members re geared to 4:88 and ARBs installed at a shop. Took it on a test drive and I am getting a pretty good vibration in the front end around 55-60mph mostly on deceleration, gets a little better without front...

A few from a trip out west

95 FZJ80 3” Dobinson w/35s Roof rack. Arb front bumper w/ winch Home built console and rear drawer system Triple lock almost complete