Recent content by BramJan40

Hey woggsy. Pm me.

Yeah. Sure. Where in aldergrove are you. Can message me too

Are you doing a full rebuild? I may have a used one with a vac pump in the shop. It would be for a 3b believe it’s a 50A one.

My wife and I plan to come. I will see if we can bring an appetizer

Some bolts I definitely noticed a quarter turn. But I’m going to double check with steve at EBI. But I may be mistaken. I believe you need to loosen all the bolts in the correct pattern and then re torque but I could be wrong. Been a couple years since I rebuilt my engine. I’ll get back to you...

Might be a silly question, but after you put the head back on and topped off the coolant. Did you let it run with the rad cap off to let all the air bubbles out? Did you also re-torque the head after a full engine heat soak? I believe the mls gaskets need to be re torqued 2, if not 3 times. I...

I would have a very hard time drilling a hole in the tank… but then again, to have its own fuel supply would be best For when running the truck and the heater.

Hi, would you by any chance have a 2h flywheel, clutch fork, starter, and the throwout bearing? Cheers

I’ll take the interstate battery.

Do you have a the 2h bell housing?

Is the bell housing available?

Send me a message I may have one.

Pmd

I would take it but I’m on the mainland..

I as well have a Christmas party that evening. Am I assuming correctly that it’ll be an evening event? If so i will be a no show.