Recent content by Blue Coyote

  1. B

    Build 91 FJ80 resurrection- aka Berner Bus build -

    Update time - got a dusty box of ACL rod bearings (made in Australia printed on the box even). Cleaned the journals up a bit with 500 grit paper. Put the new bearings in and Plasti-gauged them. The worse was .0018 or so - with most around .0015. I do not have a FSM yet but based on my past 22re...
  2. B

    Build 91 FJ80 resurrection- aka Berner Bus build -

    It always had a slight clatter at start up - but was not concerned. Wife takes it for the maiden trip to work - and well not a good one. It was bogging down to 20 mph on the hills (kick down cable) and clattering and higher rpm- uh oh. And had no heat either- which I think is a tight fan clutch...
  3. B

    Build 91 FJ80 resurrection- aka Berner Bus build -

    And it had LOTs of leaks and was a greezy mess. After a gallon of purple clean and hours with the pressure washer it was tolerable. Installed a new water pump, belts, idlers and retourqed all the loose oil pan bolts. The front axle was soaked - and like everyone we looked at needed a front axle...
  4. B

    Build 91 FJ80 resurrection- aka Berner Bus build -

    We needed something big enough to haul around the furry kids / paddle boards, camping / hunting / remodel stuff. Had to survive PNW winters, parking lot trauma, scrapes, dogs, outdoor use. Have lots of experience working on Toyota’s, so what better than an older FJ80 or Sequoia. After looking...
Back
Top Bottom