Recent content by bimmerjosh

  1. B

    My project 80 is putting up a good fight.

    If that’s what it is that’s what it is, I’d obviously prefer not to rip it all back apart but another HG is preferable to engine replacement. I ran an inspection camera up those tubes and there’s a trail of coolant all the way up to where the block and cylinder head meet, so I believe it to be...
  2. B

    My project 80 is putting up a good fight.

    Yes I should have mentioned, I have ruled the oil cooler out. When I bought the truck the original oil cooler cover had a crack, so I purchased a very expensive replacement cover from Toyota. While it was apart I put the finned cooler part into a pan of water and plugged it with tapered plugs...
  3. B

    My project 80 is putting up a good fight.

    I really wanted to do a formal introduction and project post but I'm in need of some wisdom from those familiar with these great vehicles. Spring/ early summer of 2018 I picked up a cheap 94 FZJ80 that was a stalled head gasket project started by the previous owner. Most of the engine bay was in...
  4. B

    Help identifying noise after head gasket job

    Update, I popped the starter out and the noise is gone. Whew. Now to figure out what I did wrong on the starter...
  5. B

    Help identifying noise after head gasket job

    It seems to be from the bottom end but it’s tough to tell for sure because of how it resonates throughout the engine. I should mention too that I’ve put it in neutral in the video, just to rule out something driveline related. It’s strictly in the engine somewhere.
  6. B

    Help identifying noise after head gasket job

    Yes. I believe there was only 1 correct?
  7. B

    Help identifying noise after head gasket job

    Just put the head back on last night. Was rotating the engine by hand to check the timing today after cam install and there’s a a decently loud dragging/ grinding noise. This obviously has me frustrated and nervous so I’m hoping it’s something dumb but I’m expecting the worst. I really don’t...
  8. B

    Wait, is that a factory locker... only one?

    More into just rehabbing an older vehicle as of right now, but I'll have some fun with it along the way. Genuine thank you for the help, I have a good direction to go in, and my to do list got a little longer.
  9. B

    Wait, is that a factory locker... only one?

    Assuming it works when I test it, would that be as simple as hooking up a toggle switch with reverse polarity to the separate pins? Is there any other electronic wizardry going on? I think it was slee or a post on here somewhere that mentioned a computer.
  10. B

    Wait, is that a factory locker... only one?

    Hi all, first time poster here. I'm a new '94 fzj80 owner. I bought it as a non running project rig and have just been going through doing a ton of base lining and refreshing of what is now a 24 year old vehicle. When I purchased my LC the PO was adamant it did not have factory lockers and after...
Back
Top Bottom