Recent content by bhend101

Any update on springs?

Thanks for the info! The PO made a mess of the wiring, I have been spending time cleaning it up. I will continue to look for the issue as I clean up wiring.

They are bottomed out. I have only removed the cluster and reset the wire harness, is it worth taking these Further apart and re assembling? See if there is anything more internal that is loose?

Thank you for sharing diagrams. I will do some ground checking. The High Beam, Fuel, Voltage, Brake, and Seatbelt all work. Just those two that are down. I am wondering if when I pulled the cluster out I shorted those two boards out somehow?

The Oil Pressure and Water Temp quit working on me. (at the same time) I have check fuses and have reseated plugs and can not get them to work. I have not changed sending units I did remove the cluster unit and change Bulbs, they both worked after this. Not sure where else to look, Aany advice...

Thanks, I will dig around for the FSM.

Thanks for the reply. Additional ?s 1) How do I know which terminal is Power and which is Park? 2) I assume the power needs to be feed from a 12v constant? The Power from the Switch is wired right now to 12v Ignition? 3) Park just wires to Park on Switch?

Need a little help. My wiper motor is wired with a toggle switch, the two wires in pic go to switch and the switch has a 12v to Fuse Block I know these two wires are high/low speed Anyone know what the other two terminals are. Park and 12v?