Recent content by Bellbuster

Dude thank you for all your help with this and all these schematics! Really can't thank you and everyone else on here enough. I'll keep digging tomorrow when I have light and see what I can figure out.

My only other guess at this point is it is rigged up to the oil pressure sending unit or something along those lines. I wonder if just replacing the oil pressure switch wire harness (82221-60020) would allow be to just pull this wire

AC works great and AC clutch only cycles on when I turn the AC on

So I tried touching it to the positive terminal with the engine off and did not hear any clicking of any sort.

I'll give that a test when I get home from work tonight.

I have been cleaning and fixing things on a 1996 80s series landcruiser and was hoping for assistance on identifying a strange wire. There is a red wire that was hooked up to the positive terminal of the battery. I traced it to being spliced into a black wire with a white stripe over near the...

New fuel filter and all the bits needed are on the way. Went ahead and ordered a new fusible link and the box because it was cheap enough and why not. I'll get the filter switched this weekend and then use some elbow grease and patience to go through all the connections and make sure everything...

Hello! When I tried to crank it I tried in both park and neutral. Vehicle had electrical power as the dash lit up and the radio came on.

Battery terminals tight and checked around. Everything seems good, but when I have time this week and not in the middle of the woods I'm going to go over it again

I did not notice for certain, but it currently is on for the up stream 02 sensor failure. I have a new sensor, but the stud broke off so I have to have a new 02 attachment plate welded on. I have a code reader that I check it with before driving and it is throwing no new codes. I checked today...

Apologies for sounding like a rube, but was hoping for some advice. I have a 1996 FZJ80 and today while on a trail on a slight up hill I turned the engine off. When I went to go crank the engine again it sputtered and stalled out. I fired it up again and throttled it up to get it to some flat...