Recent content by Aussie BJ73

  1. Aussie BJ73

    BJ73 steering question

    @Sundowner @Felde Thankyou guys for you suggestions 😁, I have improved it by adjusting the toe in a fraction more, loosened the clamps off, rotated the shaft a bit, then tightened back up until it was steering nicely. Now if I hit a bump, it won’t go everywhere. The steering wheel however still...
  2. Aussie BJ73

    BJ73 steering question

    I’m thinking of going back to the narrow tires it would have come with from factory just to see, I may have access to a set just to try. Believe so, Ill check that later to make sure
  3. Aussie BJ73

    BJ73 steering question

    I did forget to mention about that but bj70bc, I’m assuming your talking about the one on top in the middle, loosen the nut then tighten the thread with a flat bladed screw driver? It’s always been near the end of its adjustment in the down position since I’ve had it I’ll look into the shims...
  4. Aussie BJ73

    BJ73 steering question

    Hi all, first time posting in the forum, visited a few times online but figured I’d register today, some very nice and interesting vehicles on here 😁. Hopefully I’ve picked the right spot to ask my question 👍 I’ve got a 1985 model BJ73 FRP top, has around 377xxx KM on the dash, 3B diesel which...
Back
Top Bottom