Recent content by An3

I've been working on a few projects! Here's the '79 Dana 60 a little cleaned up. Found out that it's a 4.10 ratio and had very clean gear oil and tight tolerances Finally got my new bumper mounted with the winch ready to be wired up while I wait to slap in the new CVs 4Runner project is...

Great, I may send you a message in the near future for parts. I'll probably go with a 14 bolt for the rear to keep the same bolt pattern

Here are some more fun pics of the axle pull. @CrabCake getting down and dirty. I think he had more fun than me! @matzell did I hear you have Kingpin parts?

This was aftermarket. It blew the OEM one the day beofre

This CV was less than 24 hrs old

I've been working on the Coastal Offroad DIY bumper for my 4Runner. Almost 100% welded and ground smooth. For a novice welder, I am pretty proud of how this came out. Deer don't stand a chance now For the Xploder - this was a fully welded bumper that I added a middle hoop to after this pic...

If only these came a few days earlier…

Almost had to back out last minute due to a wild weekend. We had a bat in our house which made my entire family have to get rabies vaccines, luckily the 3rd round of shots was able to get pushed till after the weekend. @CrabCake and I will be loaded and ready for some fun! :banana:

Now you’ve got @CrabCake ‘s attention

I’m still in!

Shout out to @TRDdrew for the help with insurance on the 4Runner. It was a very smooth process and already got my claim pushed through. Time for a new bumper!

I'm in a similar situation. Just hit a deer and looking to install a full steel bumper and new front springs if needed

It was a great trip. The trails we mapped were fun and doable for everyone in our group with minor winch action in V Notch with Kevin’s 61 On the ride home I almost got taken out by a hydroplaned car which, very thankfully, missed the truck and trailer Sunday was a different story - it may be...

Did we all agree on 8:30 arrival?

Ill drive it right on my trailer