Recent content by a200

That looks like a good time. Hot Springs is a fun town.

Wish I could.

I used a horticulture spray pump modified with a length of tubing.

I just started the truck and let it run for a few until the pump shut off. I just followed what others around here did.

100% do it ASAP. Berkshire Hathaway ownes the only dealership near me, and quoted $15k for the repair, criminals. I fixed it for $500 laying in my garage and half a Saturday. 3 of my globes were blown from what I can tell. If your 200 is over 10 years old, do not delay. I wish I had done it...

I would replace your globes asap if they are damaged. You are putting a lot of stress on all the other components.

I have external sensors with metal valve stems. I will 100% do internal sensors next time.

I got the Hewitt kit installed. I got hands on the drivers side connector and it cracked at soon as I pressed the clip. I used a small screwdriver the get it to release. I used a small zip tie to keep the new connection snug. The same thing happened on the passenger side. I got both the block...

Forever trucks go well with forever campers.

Any update?

Thanks, I appreciate that. The reason I am throwing in the towel on taking the 200 is only because I have a good alternative adventure/tow vehicle in the form of a first gen tundra(on a side note I will be down near you at Maumelle Sun-Wed. You should drive though if you are close). So, did you...

It looks like you have some water damage. Have you fixed the leaks?

I had the actuator replaced at the time of sale, so around 2 years ago now. The lights came right back on about 30ft down the driveway this morning. IT sounds like damage to the sensors can happen if I keep driving it with these codes. Any thoughts on that? I think the 200 is setting this one...

Alright I confirmed I was just in limp mode. My test drive through the yard and up the driveway felt like I was geared to high for low but obviously something was wrong so I jumped the gun on what I thought was happening. I cleared the code and went for a drive. All was normal. I got it up to...

I am all stock under the hood. I will take a look though. Is that the kit you have on yours? I am going to reach out to them today. That seems like the fix though.