Recent content by 87MantisCruiser

One month bump

Just bumping this up before I scrap it!

$50 plus shipping. Thought someone might be able to use it! Will include vanes in case someone wants to rebuild and actually use it. Degreased it, ready for shipment.

Thanks everyone who has responded so far!

Good afternoon! just looking for opinions and alternative ideas. I am trying to choose between options as to what I should do with some screw holes from an old roof rack on my 1987 FJ60. There are 24 of them... From research it appears that some of them were from chrome rails that ran lengthwise...

Haha added. That will teach me to not post while drinking!

Works with ARB and other offroad bumpers. Heavy duty. Includes free spooling clutch, 162:1 gear ratio, Spydura synthetic line, and a remote control. Rated for 12,000 lbs. Comes with wiring. Lightly used. $1200.

Ah, now I understand! Yes the pitch does change based on rpms. It is lower at lower rpms

It’s not super noticeable in the bottom of first gear or the top of fourth gear. It definitely fades away after 55mph, but that could be just road noise covering it up. Very noticeable in second and third and most of fourth ( video shows 2 to 3)

Definitely different then what I am hearing. I added a video above of mine

UPDATE: tonight I think I narrowed the issue down. As I mentioned, the whine occurs when in gear in both 2wd and 4wd drive. In an effort to isolate the issue further, I locked the hubs but out the transfer case shifter into neutral to disengage the drive shaft. I then put the truck into first...

So I went under tonight and greased all the u joints. The rear one seems to have a little movement. Could it cause this sort of noise? I don’t notice any vibration when driving.

Doesn't that seem unlikely though, considering the recent rebuild by a Toyota dealership? Or are the commonly installed incorrectly/go bad. I have the receipts and all parts that went into the rebuild were Toyota OEM