Recent content by 80series STD

Thanks for you help with this. Could you have a look at the three photos below and see if the seals are the correct way?

So the housing for it has a slight recess that is bigger then the location for the crankshaft seal. Once i turned it over it was exactly as you mentioned. I've scoured through my repair manual however i'm having trouble understanding which way the thee seals (cam seal, crankshaft seal, and...

I'm doing the timing belt and water pump for a 1hzj80r and the camshaft seal that was supplied does not fit perfectly in the housing. Is this an issue or will it warm to the correct size? Photos attached Thanks, Tim

How stupid that i forgot actual usable info! 1993 standard 80 series 1HZJ engine HZJ80R Imported to Australia

Hi, I've been searching through the landcruiser manual for the part number for the injection pump timing gear but can not find it. Also can anyone tell me if i can just order the top part where the bolt has snapped off in the photo i've attached? Thanks

Can anyone help me identify what these are and what they're designed to do? they came in the timing belt and water pump kit but i just cant figure out what the hell i'm ment to do with them. The only place they look like they can go is ment for metal parts and these are plastic. Thanks

Hey thanks for the help. I managed to get it off but not without some dramas. I used my puller that i bolted on to the injection gear drive bearing, but when i tried to force the pump out the bolt snapped. Now i've gotten up to taking everything apart but cant understand how to undo this large...

Hi all, I'm in the process of identifying a fuel leak in the side of the diesel injector pump. I have removed a few components but am struggling to understand how to remove the nut in the photo. I have watched a few videos and consulted the repair manual but I feel like I need it explained to...

You are very correct. I certainly didn't prime it anywhere near enough. Good news is it now turns over! I noticed a leak coming from the injection pump body. What should I do next? I think i should take off all the injection pump assembly and refit them in case it didn't go on square last time.

Hey guys I need some help to understand why Beast wont turn over. I've replaced the diesel injectors because one had a leak in it. I spent this morning putting it all back together again. The car sat apart for about 2 weeks while I found the correct injectors. I've had the key on the...