Very close to it. Even after using a spot weld drill set up some are not completely removed. That’s when it gets difficult. The weld has more hardness so cutting the portion still attached is challenging. Partly because it’s hard to tell which one and where. Also getting a narrow tool in the...
Thanks, it’s going to be an adventure. I’m making tools as I need them. I started making a sheetmetal brake today out of some salvage metal. Should be a zero dollar project.
Lining up the roof. There was a big hump in the middle. So I used click straps to force it down and stretch it out. Clamps on the front corners to line up the windshield frame.
The underside of the roof was painted yesterday. It was 40 outside, and my temp spray both is a shed roof wrapped in 6ml plastic. Got it up to the middle 60s then sprayed it. Hardened up nice over night. Today we placed the roof on the 55. Next comes the final fitting and more than 120 welds...