Recent content by 17cmh

  1. 17cmh

    Engine Cutting Out

    So I threw in the towel and took it to a mechanic. It was a combination of one of the distributor coils that was bad and a bad ignition module. Hoping that if someone else has this issue, this thread may help point them in the right direction
  2. 17cmh

    Engine Cutting Out

    It was running last week and before, seemed to only have issues when engine was hot. Then wouldn't start at all. Replaced everything above and got it to run, but performed poorly at all speeds this time.
  3. 17cmh

    Engine Cutting Out

    I can't even get it to fire now. I checked the spark off the ignition coil with one of those inline spark plug testers and grounded it. Still nothing
  4. 17cmh

    Engine Cutting Out

    Sorry, yes, it is illuminated. Ran code, CODE 1, no issues :/
  5. 17cmh

    Engine Cutting Out

  6. 17cmh

    Engine Cutting Out

    Just noticed that there is on check engine light
  7. 17cmh

    Engine Cutting Out

    So yes, when going down the highway, it would cut out for 10 seconds and the shudder on and off before continuing. After the coil and spark plugs, I got it to run but poorly. It was cutting out more often, but less intensely.
  8. 17cmh

    Engine Cutting Out

    So I replaced both MAF sensor and distributor cap and rotor, no change
  9. 17cmh

    Engine Cutting Out

    I have a 91 FJ80 with the 3FE inline 6. I've been having issues lately where the engine cuts out, shudders, backfires or dies when I'm driving. It happens for about 10 seconds and kicks back on again. Seems to be agrivated when the engine is warm. Haven't had issues before, but I just got it and...
  10. 17cmh

    FJ80 Rear Axle Repair

    As requested!
  11. 17cmh

    FJ80 Rear Axle Repair

    I have a local wrecker who has a 96 FF. Will that fit without extensive modification?
  12. 17cmh

    FJ80 Rear Axle Repair

    I am the new owner of a 1991 FJ80. It had a hard life in northern Idaho and I am trying to resurrect it. The rear axle has a botched repair job (see pics). I'm curious on how to proceed; would you recommend replacement or is there a way I could get a weld on bracket and cut out this mess. Mostly...
Back
Top Bottom