Recent content by 13A1V1

Here is a snip from the Cummins R2.8 Installation Guide. I am all for swaping out the tach in my Prado with an alternative but am hoping to keep the dash original. Would there be another Tach out there for example, from a USA 4Runner or Tacoma that I could pillage and replace my Prado guts...

Can I redirect your reply to my thread on the subject? Thank you kindly! Help Needed with Tach on 95 KZJ71

Regarding the tach and Dakota Digital adapter, can you share any wiring details? I have been stuck on this part or my conversion.

Swaped a 1kzte with a R2.8 but no matter what I try with the Dakota Digital I can’t get the tachometer to move at all. Can you share any insight?

Did an engine swap from 1KZTE to a Cummins R 2.8. I have all the dash indicators converted over and functioning properly except for the Tachometer. There are 3 wires coming out of the back of the Toyota tach. However, when I connect to the signal wire to the Cummins signal wire I get no...

1KZ-TE engine for sale, $2500 obo. Removed from 1995 KZJ71 Prado. Approximately 165,000 km when I pulled it. Engine, radiator, air box, a/c compressor all included. $2500 pickup only, Pueblo, CO. Frozen engine caused me lose all compression. Pulled the head, it was warped. Replaced the new...

I had about 5 hours into the vehicle driving home after I bough it. Had some crazy -20 over night weather and I then things froze and that was that. Head warped and lost all compression. Replace the head, the gasket, all 4 injectors, water pump and belts but could never get compression fully...

I actually lined up perfectly. It is very snug to get the a/c condenser, intercooler, radiator and fan mounted in front of the engine. It fit with 3/4" between the fan and pulley. I will get some better photos this weekend when I swing by the shop where they are doing the install.

I’m down south in Pueblo.

Hello everyone. Just wanted to introduce as I am a newbie to the forum and to the 70 series. My new rig is a 1995 Prado that is nearing completion with a Cummins R2.8 swap. There is a sad story here and some tech assistance needed, but that is for later. Imported this one from Japan so she’s a...