LandCrusher'70

Another FJ62 converted to H55f, new transfer case with 10% overdrive high range, our CruiserMatt’s FJ62 exhaust setup. It’s also getting a new carpet and a new OE dash board. FJ62’s are my favorite, especially red ones 🥰

Got the t case flanges back together and burr free. Installed drive shafts. Installed brake lines, new master cylinder, and bled the brakes. I only removed the lower caliper mounting tabs from the knuckles. The top cleared everything and I used...

1989 62 series Kim Val Kilmer (VA7KMR) 200,000 miles...ish 12H-T, H55f, cable locking axles, suspension seats, ARB 2 1/2 lift, 1 inch body lift, on 33 or 35 inch tires.

Learned to weld!

1987 land cruiser FJ60 Owner :Kyle Vehicle name :TBD Mileage 187994 Mods: chevy 350 engine ,Holley ignition system, Ranger torque splitter overdrive. Needs some love but plan is to fix it up and camp and play in it. If I get it running good...

Used the 60, with a Warn 12k winch, to pull the 80 from a mud hole. Needed the tractor as anchor to hold the 60 in place.

Not sold in the USA? Saves me telling Toyota it isn't a Land Cruiser. Certainly not a viable FJ40 replacement. When will Toyota learn. Jeep sold about 200,000 Wranglers and Gladiators in the US. Toyota sold 45,000 Land Cruisers yet they still...

My last rescue in August right down the rd from a realtor buddy. The homeowner didn’t wanna take it with him to the desert and claimed it was to slow 🤣 he wanted to see if go to a good home. Couldn’t say no to this one either 1966 definitely a...

Camped up in Flag and stopped in at the overland expo for a while… spotted a couple of 62s including one that Dirt Every Day’s Fred (red) recently picked up.

Got to park my 60 on the side of the runway at the airshow this weekend. Took all of these photos with a manual focus vintage lens on my wifes digital camera. Probably the worst setup for taking pictures of moving airplanes.

Getting ready for some summer sales here in the barn!

Rally event in Samuel dunes (Fayoom) Egypt.

Since I’m new I wanted to post my car to show somewhat I’m working with!!

Hey everyone, re-posting this from the 80 page: We’ve been developing a Bosch iBooster mounting bracket for Land Cruisers, and I finally got a chance to put it through a proper test. I installed it in my 80 and took it down to Moab—hands down...

I always use the Poway Smog Station (in Poway…) for my 80 Series. The 62 will head over there when roadworthy. Family and friends have used them for years.

My slave cylinder went out on Monday. I replaced the flexible hose and cylinder. Adjusted it and now it’s dialed. Could not of done it without all the great resources within this site. Added bonus drove it into San Francisco to celebrate 19 years...

Been selling and shipping tons of FJ62 exhaust kits! Need to get them onto the website.

I'm sure I'll be reading through the site quite a bit in the upcoming months. Hasn't run in quite awhile, got some rust but seen worse

Successful test fit Bracket needs a few tweaks but works ok as-is. I’m working towards a kit so these 80 Series alternators drop right in.

Bath and a wax and oil change to hopefully pass CA Smog tomorrow. Then clutch time to get it ready for my kids to follow me on Rubicon this summer in it.

Dropped a very heavy rebuilt 3B w/Turbo into this cool G-spec BJ60. Lots o’ pulleys on this old tractor engine.

No more antifreeze down the armpit on the block coolant peacock!

Got a solution for that 😉 But living with these trucks is a process with a lot of different paths over a long time. Choose your own adventure!

I finally finished a proper coolant job and rebuilt my fusible link this weekend.

Lastly, pat your 13 yo son on the back for learning this. Next - on to the locking hubs! Please note I had to look up many of these instructions piecemeal from other posts so I cannot guarantee they are correct! I used FSM where possible but...