will BJ60 or hj60 fan clutch fit BJ70?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 3, 2003
Threads
71
Messages
704
Location
S. Lake Tahoe, CA
I'd like to replace the fixed (solid) fan coupler with an o.e.m. fan clutch but can't seem to source one for a bj70. But I can source them for 60's, both bj and hj. Does anyone know if it will fit? I'm thinking they will but would like to confirm this. Part # would be a big help also.
Thanks
 
yes. 60 and 70 (3B engine) will fit.
 
all of the 4 bolts that the fan clutch use to mount to the pulley fit. The 60 fan clutch won't allow the 70 plastic fan to mount on it. I guess you can buy the 60 plastic fan too. One of the things I haven't done yet is to find out the diameter of the 60 fan to make sure it fits the 70 shroud.

I do know that the mid 80's pickup plastic fan is the same as the 70 series. part # crosses over. so you could run a mid 80's pickup fan clutch and it would bolt up. I dunno if it engages differently from the 70 fan since it's a different # but it can't be that far off.
 
Thanks for the replies.

I talked to Dan at 4wheelauto.com in Edmonton and he's sending out a water pump and a fan clutch (viscous coupling). He was very patient, and thinks my fan will bolt up to the new fan clutch.

My current fan mount is a viscous coupling modified to be solid by being drilled and through bolted so I don't think I can just add the fluid back to it.

Thanks again.
 
Back
Top Bottom