Where does the wiring plug in on the front e-locker?

Joined
Feb 28, 2007
Messages
238
Location
TN/GA Line
I've done my rear and factory wired it to my cpu on the drivers kick panel, installed the locker CPU, and diff lock switch. All is well and there is much locked up joy on the rear.

My question is where do you hook up your front factory e-locker wiring? Is there a prewired plug in waiting on the firewall or somewhere? I've got the front harness ready to go.

I've searched the threads and haven't found the answer. Thanks in advance.

:steer:
 

Cruiser804

SILVER Star
Joined
Mar 11, 2006
Messages
1,797
Someone posted some pictures here a while back for me. If I can find them I will post them. But basically it runs from the plug, down the body down across the frame. If you lay it out you will start to see where the clips plug into the body and frame. The insulation ends with the fender. I thought is would run a little further down across the frame but I couldn't get it to work that way
 
Joined
Jul 14, 2004
Messages
2,555
Location
on the right coast
My question is where do you hook up your front factory e-locker wiring? Is there a prewired plug in waiting on the firewall or somewhere? I've got the front harness ready to go.

I've searched the threads and haven't found the answer. Thanks in advance.

:steer:

The connector is located on the passenger side firewall. That's where you connect the front diff lock harness.
 
Joined
Feb 28, 2007
Messages
238
Location
TN/GA Line
Mine turns out to be on the passenger side fender well by the antenna access area. If you have that pic please post it. I'd like to see how the harness was ran down to the axle.

Thanks for the replys.
 

landtank

Supporting Vendor
SILVER Star
Joined
Mar 27, 2003
Messages
20,146
Location
Groveland MA
it sarts at the Cruise control actuator, runs along the fender to the spring tower, down to the frame and back to the rear of the sway bar and then along the sway bar to the locker actuator.
 

Users who are viewing this thread

Top Bottom