- Joined
- Oct 31, 2008
- Threads
- 67
- Messages
- 815
- Location
- Napa Valley California
- Website
- www.mosscreekwinery.com
I have searched everywhere and have not come up with a clear example of what I am looking for. I have a 1969 fj40, with a front disk conversion and replaced back cylinders with 10mm cylinders. I have a booster/master cylinder setup with 2 lines. My question is where do I run the new brake lines. I figure the front I will do just like it was previously from MC down to frame then over to other front brake.
I have seen several different methods for the rear. I would like to go straight down and back rather than over the engine. Pictures would be great or previous threads where this has been done.
I also need some 10mm fittings. All the fittings removed from my 1969 are 9mm.
I have seen several different methods for the rear. I would like to go straight down and back rather than over the engine. Pictures would be great or previous threads where this has been done.
I also need some 10mm fittings. All the fittings removed from my 1969 are 9mm.