Where do 35's rub?? (1 Viewer)

[Mace]

Figure a stock front end FJ60.

Has anyone stuffed a set of 35's in their rig without lifting it?

Where do the tires rub?

I do have some 2.5" shackles and the fenders have been cut quite a bit.

I am just wondering if I can get away with flat towing with a set of 35's without too much rubbage.

 

[SHO NUFF]

Here's were they rub in front

 

[SHO NUFF]

That's stock suspension and stock rims with bfg 35/12.50s.

 

[Mace]

That's awesome.

35's away..

 

[Man Jerk]

They rub on the front of the inner fenders when the shackle swings forward. I unbolted the front inner fender and cut the lip that is behind it then tacked the inner fender back on. They also rub on the inside of the rear wheel wells but there isn't a whole lot you can do there unless you cut it all out, but it doesnt do much to the tire.

 

[Mace]

rear is in a Spring over config.

The front is not going to be. Most likely a 2.5 or 4" SU config..

 

[Tapage]

rear is in a Spring over config.

The front is not going to be. Most likely a 2.5 or 4" SU config..

but with 4" lift in your front leaves hoy have a really strong spring pack .. don't think so .. ?

 

[Mace]

yeah, but the SO in the rear is recessed into the frame. If I so the front end it will sit ass low.

 

[BlueCruiser84]

That's stock suspension and stock rims with bfg 35/12.50s.

Do you wheel that rig?

 

[SHO NUFF]

Do you wheel that rig?

That's where the rubbing came from. Check out this thread.
https://forum.ih8mud.com/showthread.php?t=50869&page=1
I'm SOA now.

 

[BlueCruiser84]

that's bad ass. i want 35's

Brian