wheel bearings for a mini conversion same as FJ40

Discussion in '40- & 55-Series Tech' started by petescoffee, Mar 20, 2004.

  1. petescoffee

    petescoffee

    Messages:
    1,898
    Likes Received:
    50
    Joined:
    Dec 29, 2002
    Location:
    Walnut Creek, CA
    Here's the background- Mini disc break conversion was done by previous owner. I recently did a complete knuckle rebuild and replaced the wheel bearings.
    Now the disc break calipers are not close enough to being centered over the disc to be called good.
    So, I was wondering if I used the right wheel bearings.
    Are the Landcruiser Wheel bearings and Mini wheel bearings the same?
    What else could cause the caliper to not be centered?
    Thanks

    The FJ40 is a 1975.
     
  2. beanz2

    beanz2 Moderator

    Messages:
    2,126
    Likes Received:
    6
    Joined:
    Nov 16, 2002
    Yep, they're the same.

    I'd guess the hub wasn't pushed past the new stiff spindle seal to seat all the way in. Can you even put both spindle nuts on?

    Dave
     
  3. petescoffee

    petescoffee

    Messages:
    1,898
    Likes Received:
    50
    Joined:
    Dec 29, 2002
    Location:
    Walnut Creek, CA
    yeah both nuts went back on. I will have to pay closer attention when I put it back together.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.