Wheel alingnment after 2" lift (1 Viewer)

[BobBJ74]

I've lifted my 120 with Ironman 2 inch B rated coils front and back and installed SPC upper control arms. Should I use the factory camber, caster and toe values for realignment? Tyres are BFG AT 265/70/17.
Thanks.

 

[Junior357]

Haven't lifted mine yet...but what I keep hearing is to max out the caster and set everything else back to factory specs. But honestly...I am repeating what I have heard without empirical evidence or experience.

 

[BobBJ74]

Thanks for that info. Had them set at the recommended +2 degrees but had excessive wear on tyre outer edge.
Going for alignment tomorrow, I'll post my results.

 

[Junior357]

Thanks for that info. Had them set at the recommended +2 degrees but had excessive wear on tyre outer edge.
Going for alignment tomorrow, I'll post my results.

Outer edge wear is usually a camber misalignment. Usually camber out (away from the frame) at the top of the tire.

 

[BobBJ74]

Thanks again. My local tyre shop guys d'ont have much experience with lifted 4x4 alignment, so a bit of trial and error!!
But we will get it sorted.