What’s the purpose for this ? 1/4 Tray (1 Viewer)

[lp2k]

ANSWER:
THE 2 OPENINGS AT THE END OF THE SOCKET TRAY (SHOWN IN THE PHOTO BELOW TO THE RIGHT) IS FOR THE SMALLER SOCKETS.
FOR METRIC, IT IS THE 4MM SINCE THE 'CIRCLE' KEEPS THE VERY SMALL SOCKETS SECURE VS THE UPWARD PEG.
FOR SAE, IT IS THE 5/32 AND 1/8 THAT GOES INTO THAT OPENING




Hey can someone help me figure out what goes in the right side of the 1/4 tray? Thanks

 

[jivewalker]

Hey can someone help me figure out what goes in the right side of the 1/4 tray? Thanks View attachment 2871999

Extensions maybe?

 

[lp2k]

I just tried, no dice anyone else know?

 

[leonard_nemoy]

1/4" drive bit sockets. The little sockets that you hold hex bits.

 

[lp2k]

1/4" drive bit sockets. The little sockets that you hold hex bits.

Will try this once I’m back home . My OCD can rest lol