Just installed an Ironman 4x4 Nitrogas kit on my 96. I am green to turning a wrench, but accomplished the job successfully with minimal tools (added ample time)!
These are the measurements I am getting from the center hub to the bottom of fender flare:
D/S Front -560
D/S Rear - 575
P/S Front - 570
P/S Rear - 585
As you can see, there is a 10mm lean between passenger and Driver side. Also, there is a 15mm lean front to back.
My questions are: will this settle? What should I expect on final ride height? Should I leave this as is? Or try spacers?
Solutions from those who have Previously troubleshooted ride height welcome!
Still need to get it aligned and have them install caster bushing kit. Anything else I’m missing?
These are the measurements I am getting from the center hub to the bottom of fender flare:
D/S Front -560
D/S Rear - 575
P/S Front - 570
P/S Rear - 585
As you can see, there is a 10mm lean between passenger and Driver side. Also, there is a 15mm lean front to back.
My questions are: will this settle? What should I expect on final ride height? Should I leave this as is? Or try spacers?
Solutions from those who have Previously troubleshooted ride height welcome!
Still need to get it aligned and have them install caster bushing kit. Anything else I’m missing?
