What kind of transmission is this? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Just measure the overall length.

Overall Length Front to Mount Center Pan Bolts
TH200=28.25 22.25 11
TH2004R= 28.25 27.9375 16
TH350=27.625,30.625,33.625 22.25 13
TH400=29,34,38 27.9375 13
TH700=30 23 16
4L80E=32.5 30.375 17
Powerglide=25.3125,28.3125 22.25 14

There are no promises, but it seems to work for me. On a side note, one way to tell between a 200 and a 2004r is that the 200 mounts with 6 bolts rather than 10. I am assuming this is a chevy trans based on your previous posts. If its a ford or something else, let me know and ill throw another chart up. Good luck, Eric
 
Th350
 
This should work...
Just measure the overall length.

........Overall Length.....................Front to Mount Center Pan Bolts
TH200=28.25.....................................22.25..................................11
TH2004R= 28.25................................27.9375...............................16
TH350=27.625,30.625,33.625.............22.25...................................13
TH400=29,34,38................................27.9375...............................13
TH700=30.........................................23.......................................16
4L80E=32.5.......................................30.375.................................17
Powerglide=25.3125,28.3125..............22.25...................................14

There are no promises, but it seems to work for me. On a side note, one way to tell between a 200 and a 2004r is that the 200 mounts with 6 bolts rather than 10. I am assuming this is a chevy trans based on your previous posts. If its a ford or something else, let me know and ill throw another chart up. Good luck, Eric
 
Is that tranny a 2 wd unit because if it is you have already ran into some problems. Like not having enough output shaft to go into a tcase.
 
That's a th350 from a 4x4 set up. To get the t-case on it you need the adapter to go from th350 to either a np203 or np205 (different adapter.) I could sure use one of those short out put shaft jobbies, myself.
 

Users who are viewing this thread

Back
Top Bottom