WARN M47C Hub question (1 Viewer)

[Trippster]

Does anyone have a source for hub selector seal/O/Ring. I think it’s just a dust seal between selector knob and housing?
Anyway, I can’t find one. WARN can’t help, SOR, doesn’t have it.

Any help or suggestions would be appreciate! IM SURE it will be fine as long as I don’t kick up any dust!!!!!!

Thank you,

Ben

 

[Downey]

Grease will continue to ease out of the turn knob area if not sealed. I would think the o-ring is still the same as provided in the current Warn overhaul/gasket kit- - -am I wrong ???

 

[Trippster]

Yes Sir, I tried the overhaul kit and that ring was not provided. I queried about the ring, they (SOR) said there are two rings in kit. The rings are too big by far!
I guess I could try another kit???

 

[snaggletto]

Take dimensions up to Motion Industries. They can get almost any o ring you want.

 

[Trippster]

Roger that, I’ll give it a look, Thank you!

I found this 2015 thread with the same issue. He said Warn #1411 was the answer. Can’t find that part number listed anywhere. I’ll try Warn tomorrow.

Thank you all!

Ben