OK, 77-79 Federal Aisin carb on 2F in 85 FJ60 build. Just about ready to fire this up. Attached are pis of the carb, DS, from the front then PS. I have my lines numbered and believe there correct but still have a question or two..Before anybody starts...I hovered ALL the desmond numerous times, printed them, studied them but there's caveats...Some of those are different so, Picture on DS, #1 Blocked vent to Charcoal can (Don't have one..yet
#2 Choke breaker that will go to intake?? #3 I don't know... #4Blocked #5 PCV line to intake
Front view of carb, #6 Blocked, also note the return line on the card is blocked off. PS of carb, #7 Blocked,
#8 Blocked, #9 vac line to inner nipple on the Dizzy.
I'm waiting on some carb linkage and a few other odds and ends, trying to figure out the lower hoses and pipe for the radiator need pictures, parts drawings don't show anything, will have to replace the water pump so I have the extra small pipe outlet, will have AC but that's in the future. I made a pretty slick Saginaw mount from an old smog pump bracket, should work well. I believe with the prices on 3 groove pulleys I'll end up getting a sheave and machine it and put it on the two groove I have.
#2 Choke breaker that will go to intake?? #3 I don't know... #4Blocked #5 PCV line to intake
Front view of carb, #6 Blocked, also note the return line on the card is blocked off. PS of carb, #7 Blocked,
#8 Blocked, #9 vac line to inner nipple on the Dizzy.
I'm waiting on some carb linkage and a few other odds and ends, trying to figure out the lower hoses and pipe for the radiator need pictures, parts drawings don't show anything, will have to replace the water pump so I have the extra small pipe outlet, will have AC but that's in the future. I made a pretty slick Saginaw mount from an old smog pump bracket, should work well. I believe with the prices on 3 groove pulleys I'll end up getting a sheave and machine it and put it on the two groove I have.