Hi again all.
Long time no post.
Just the other day, all the windows stopped going up or down, accept for the drivers window.
This is from both the drivers controller, or from the switch on each door.
I removed the door trim, reseated the connector to the switch.
Intermittently I have had the rear left working, and less common the rear right, but never the passenger (Left) window working.
I've tried to jiggle, wobble the cables while pressing on the switch.
I've disassembled the switch and cleaned it, despite the circuit board looking pristine.
I don't think its the driver's window override lock button, as I've cleaned that, and, when one of them is intermittent, activating that switch disables/enables it correctly.
I've disconnected the three plugs going from the wiring loom to the body ECU? in the right hand drivers footwell, and sprayed in contact cleaner on them, and done the same on the connector to the switch.
It seemed a bit better, I had both rear working, but then they stopped again.
Reading some posts - some people have found cracked wires where the loom passes through the rubber gromet thingy near the door hinge, but I have tried wiggling that, moving it, with no change...
Any suggestions?
I guess I will have to pull the loom out and check it, but thought it could potentially be something else.
A resistance check on all the wires is probably worth doing I guess.
While I have had a few issues with a small amount of water getting in down the A pillar, which has caused issues in the past - such as activating the hazzard lights, this occurred after several days of zero rain.
Any advice greatly appreciated.
Long time no post.
Just the other day, all the windows stopped going up or down, accept for the drivers window.
This is from both the drivers controller, or from the switch on each door.
I removed the door trim, reseated the connector to the switch.
Intermittently I have had the rear left working, and less common the rear right, but never the passenger (Left) window working.
I've tried to jiggle, wobble the cables while pressing on the switch.
I've disassembled the switch and cleaned it, despite the circuit board looking pristine.
I don't think its the driver's window override lock button, as I've cleaned that, and, when one of them is intermittent, activating that switch disables/enables it correctly.
I've disconnected the three plugs going from the wiring loom to the body ECU? in the right hand drivers footwell, and sprayed in contact cleaner on them, and done the same on the connector to the switch.
It seemed a bit better, I had both rear working, but then they stopped again.
Reading some posts - some people have found cracked wires where the loom passes through the rubber gromet thingy near the door hinge, but I have tried wiggling that, moving it, with no change...
Any suggestions?
I guess I will have to pull the loom out and check it, but thought it could potentially be something else.
A resistance check on all the wires is probably worth doing I guess.
While I have had a few issues with a small amount of water getting in down the A pillar, which has caused issues in the past - such as activating the hazzard lights, this occurred after several days of zero rain.
Any advice greatly appreciated.